AER Compact 60 User Manual download pdf (Page 8)

5.3 Footswitch

A standard double-footswitch (on-/o-switch)

can be plugged into the footswitch-socket on the

rear side of the amplier via stereo cable. By this

footswitch the internal and external eects can be

switched on and o.

5.4 Phantom power

Microphones requiring 48V phantom power can be

connected to the XLR-socket of channel 2 directly.

Factory-provided phantom power is activated but,

if required, may be deactivated by an internal jum-

per.

In contrary 9V phantom power, if required, can ad-

ditionally be activated in channel 1 by an internal

jumper.

Please note: For both alterations the device must

be opened, therefore only qualied service per-

sonnel may carry out the modications concer-

ning the de-/activating of phantom power.

General Note: Use of 48V or 24V phantom power

(Phantom power = remote supply, here: powering

an audio device via the connected audio line)

Turn on the phantom power only if the unit connec-

ted to an XLR socket is designed to handle it!

In general, suitable units are e.g. condenser micro-

phones, active DI-boxes and other special audio

devices, whose power supply is drawn from the

phantom power. Such devices are also labelled ac-

cordingly; please heed the permissible power con-

sumption (max.10mA).

High-quality dynamic microphones with a balanced

signal need no phantom power, but can handle it

anyway.

Other devices, which have not been designed expli-

citly for phantom power operation, can suer from

considerable malfunctions and damage may result

as well.

Examples of devices that may be damaged by in-

correct application of phantom power include:

Low-cost dynamic microphones with a mono jack-

plug (unbalanced signal) that were tted afterwards

with an XLR connector.

Audio devices with a balanced XLR output (e.g. DI-

boxes, eects devices, instrument preamps with

a DI output etc.) which are not protected against

phantom power applied to their XLR output. (The

DI connectors on AER products are protected

against applied phantom power.)

Other audio devices (such as preamps, eects pe-

dals etc.) whose unbalanced line output was repla-

ced by an XLR socket.

If in doubt please consult the manufacturer of the

device you are using.

5.2 Eects

The Compact 603 has a built-in (internal) digital ef-

fect processor, with the select-switch you can choose

between 4 dierent eects:

1 = reverb 1 (short)

2 = reverb 2 (long)

3 = delay (320 ms)

4 = chorus

The efx-level-control determines the intensity of

the internal eects (left stop = no eect).

Furthermore an additional eects unit (external

eect) may be connected to the Compact 60

3. For

this purpose use the send and return sockets on

the rear side of the amplier (send goes to input,

return to the output of the external eects device).

The intensity of the eect is adjusted at the external

eects unit.

With the efx-pan control the dierent eects are

blended with the original signal. The efx-pan works

as follows:

left stop: internal eect on channel 1

external eect on channel 2

mid position: internal eects on channels 1 + 2

external eects on channels 1 + 2

right stop: internal eects on channel 2

external eects on channel 1

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

AER Compact 60 User Manual Page 8

Comments to this Manuals

Related products and manuals for Audio amplifiers AER Compact 60