7
4. Starting up
4.1 Cabling and switching on
Before connecting to mains, please ensure that your
local mains voltage is
suitable for the volta-
ge of the device (e.g.
120V in the USA, 230V
in Europe). The relevant
specs and safety sym-
bols are printed on the rear side of the unit.
Connect all cables according to your application
and switch the amplier on. The green power con-
trol LED indicates operational readiness.
4.2 Level adjustment
First ensure, that the master level control is zeroed
(over to far left), so that when you are setting the
sound level, the signal passes through the elect-
ronics only and does not reach the loudspeaker.
By pressing the high-/low- (attn.) resp. line-/mic-
switches you can adapt the amplier to your signal
sources (guitar pickups, microphone etc).
Turn the gain control clockwise until the red clip
indicator ashes momentarily when playing with a
strong attack. Thus you make sure that your signal
source (e.g. instrument) provides the input-stage of
the amplier with the necessary input.
The clip-LED indicates an overload. A short icker
is of no danger to AER devices. During operation a
short icker can be accepted, to be on the safe side
you should reduce the gain slightly to achieve an
optimal and distortion-free performance.
Finally set the desired overall volume level with the
master level control.
5. Functional characteristics
5.1 Equalization
The triple-/dual-band equalizer of your Compact
603 provides you with an active and high quality
sound interaction tool that supports the natural
tone of instruments and voice whilst simultaneous-
ly oering you the possibility of a controlled accen-
tuation.
With all controls in mid position the lters are set
to produce a very pleasing and natural sound im-
pression that you can „colour up“ by using the co-
lour lter with the eect of lowering the mids and
lifting the trebles. The tone becomes more open
and light and is especially suited for ngerpicking
techniques.
The equalization can support or soften the eect of
the colour lter and allows a dierentiated mids-
accentuation.
A: with colour-lter (switch pressed)
reduce treble to soften possible sharpness
B: without colour-lter (switch not pressed)
boost treble to brighten the sound
Note:
The active equalization of the Compact 603 eects
the signal adjustment. If you spot an intensied i-
ckering of the clip indicator, level the signal level
with the gain control (s. 4.2 Level adjustment).
colour bass middle treble
colour bass middle treble
Note: Level adjustment
By setting the level correctly we mean the signal le-
vel in one or several devices in a signal chain is nei-
ther too high nor too low. This applies equally to all
circuits in a complete circuit design (EQs, preamps
etc.)
Consequently, care must be taken that no part of the
circuit is overloaded or that distortion is unintentio-
nally added to the signal.
We have carefully designed the circuit to achieve this
objective whilst also providing controls for „manual“
intervention.
channel 1
IF_Compact603_20120529
Compact 603
channel 2
IF_Compact603_20120529
Compact 603
Comments to this Manuals