AER amp one User Manual

1amp oneuser manualRegister your amp one:www.aer-amps.com > Customer Service

106. Technical Datawww.aer-amps.comamp one - 2012_01_GB TD20110627 Technical dataInputs (notes 1, 4) High-impedance instrument input Mono jack, ¼” (6

117. Circuit Diagram www.aer-amps.comamp one - 2012_01_GBB080725B_20110329EXT. EFFECTSPEAKER MUTEACTIVELINE OUT PRE/POST MASTERDI OUT PRE/POST EFF.PR

www.aer-amps.comamp one - 2012_01_GB

2amp oneuser manualContents Page1. Introduction 32. Safety Instructions 43. Controls and Connections 4 3.1 Front Side 4 3.2 Rear Side 54. St

31. IntroductionWelcome to B!Thank you for choosing the amp one out of the AER bottom-line-series.This series has been specially developed for the mod

43. Controls and Connections2. Safety InstructionsThe following instructions help to minimize the risk of injury through re and electric shock.1. Rea

5compressorgnd lift signal-/protective-ground disconnecting switch: deactivated acitveheadphones stereo headphones socketline out

6Just like the gain control, the high/low switch (attenua-tor de-/activation) also serves to adjust the signal. Start at high with the switch not pre

7Note:A parametric equalizer is a lter network in which all the parameters of a lter (amplitude/level i.e. increase or decrease; frequency i.e. t

8If you turn the balance control to the left (Fig. 2), the bass range is further increased, but the treble is decrea-sed by max. 0dB.A turning to the

95.4 Rear Side Features1) gnd liftThe ground lift switch separates the earth conductor from the signal ground and suppresses humming.2) headphonesThis